Model Measurement Help Guide
Updated
Measuring Tips
We have ring sizers + measuring tapes available in studio to assist with measurement intake.
Hand Model
Ring Size - input your left hand ring finger size for ring measurements. The ring measurer looks like a small zip tie with measurement markings.
Put the end through the opening as if you were closing a zip tie. Before tightening, slip the loop over your left hand ring finger, and pull to a comfortable tightness where it won't move around, but still can slip on and off your finger.
Full body model
Measure the cirumference of each of these areas shown below. Use the mirror in studio to help if needed.
Top line = chest
Middle line = waist
Bottom line = hip
Foot Model
Measuring Foot width:
1. Lay the tape measure flat on the floor. step across the tape measure with the ball of your foot (widest part).
2. Line up the big toe side against the 1 inch mark.
3. Note where on the tape measure the left edge of your foot ends. Subtract 1 inch. If the pinky toe edge of your foot ends at 4, your foot width is 3".
4. find your shoe size + width measurement in the chart below to determine if you are narrow, medium, or wide.
Determining Arch Type: look at the chart below to find the photo that looks most like your foot print. if you are unsure, look at the bottom of your socks or shoes to understand where most wear + tear occurs.
OR you could wet the bottom of your foot + step on a sheet of printer paper. compare that with the image below + select your arch type.
Pet Measurements
